Leopard MBT: Difference between revisions

From Air-Force.ca Wiki
Jump to navigationJump to search
No edit summary
No edit summary
Line 36: Line 36:


Reproduced here under the terms of the DND Non-commercial Reproduction notice availible at:[http://www.forces.gc.ca/site/notices_e.asp]
Reproduced here under the terms of the DND Non-commercial Reproduction notice availible at:[http://www.forces.gc.ca/site/notices_e.asp]
CASR DND 101 HOMEPAGE:[http://www.sfu.ca/casr/101-0intro.htm]


[[Category:Land Force Vehicles]]
[[Category:Land Force Vehicles]]

Revision as of 20:59, 19 May 2006

The C2 is an updated Leopard 1A5, which was developed in Germany in the 1980s. This tank deploys with a crew of four, including a commander, a driver, a gunner and a radio operator/loader. The 105-mm L7A3 gun is capable of engaging targets day and night, while on the move under adverse weather conditions, through the use of a fully stabilized fire control system with an integrated thermal imaging system and laser range-finder. The Leopard C2 Tank is also fitted with a gunner’s secondary fire control system and a commander’s fire control system. It has two 7.62-mm C6 machine guns. One is mounted inside the turret and another can be mounted externally on either the commander's or the loader's station.

Spall liners have been added to the refurbished Leopard 1A5 turrets to increase crew protection — slightly reduced interior room being considered an acceptable trade-off. Protection was further improved by the application of add-on MEXAS composite armour panels. But, the Leopard C2’s EMES18 fire-control system with its thermal night sights made the biggest tactical difference. [1]

Leopard C2 TankThe Leopard C2 is also fitted with two banks of four smoke grenade launchers on the turret. The tank may be “sealed-off” against nuclear-biological-chemical (NBC) threats. It is a minimum-maintenance armoured fighting vehicle and complete replacement of the engine and transmission is possible in 30 minutes under field conditions. When properly fitted with a conning tower, it is capable of deep-fording or submerged fording where riverbanks are prepared for exit and entry.

The Leopard C2 was designed so it can be fitted with add-on armour and all of the new battlefield sensing and communication systems the Army plans to introduce over the next few years. There are 114 in service.

The DND has said that it is replacing the Leopard C2 "with a new direct fire system that includes ... three platforms”. All three platforms are LAV III-based – MGS, a new anti-armour TUA TOW missile launcher, and a new dual-use anti-armour/anti-aircraft ‘Multi Mission Effects Vehicle’ using ADATS missiles.[2]

Variants:

  • Armoured Repair and Recovery Vehicle (TAURUS)
  • Armoured Engineer Vehicle (BADGER)
  • Bridge Layer (BEAVER)

Armament:

  • 105-mm L7A3 gun
  • 1 x 7.62-mm co-axially mounted machine-gun (C6)
  • 1 x 7.62-mm crew commander's machine-gun (C6)
  • 76-mm grenade launchers (2 clusters of 4 launchers)
  • Ammunition types: Armour-Piercing Fin Stabilized Discarding Sabot (APFSDS)
  • High explosive squash head (HESH)
  • White Phosphorous Smoke (WP)

Specifications:

  • Length: 8.17 m (gun at 6 o'clock), 9.54 m (gun at 12 o'clock)
  • Width: 3.37 m Height: 2.62 m Weight: 42.5 t
  • Engine: Multi-fuel engine, 10 cylinders, 830 hp
  • Speed: 65 km/hr
  • Range: 600 km
  • Number in Service: 114

Source DND: [3]

Reproduced here under the terms of the DND Non-commercial Reproduction notice availible at:[4]

CASR DND 101 HOMEPAGE:[5]